OPERATING LEVELS
3.2 - 5. Level : Parameter settings for the heating engineer
Access the settings list (with the exclusion of some) of the control unit LMU via the sensor
!
QAA73 and first level settings.
Buttons Explanation
Press on the both line selection buttons and setting buttons beginning with the button .
- This will take you to the first programming mode "LMU" (4. level)
Successive display:
1
P ROG
et
Line
Press both line selection buttons for at least 3 seconds.
- This will take you to the second programming mode "LMU" (5. level)
Successive display:
2
P ROG
b) c)
3
4
5
P ROG
Press the line selection buttons to select the required line.(rep. b).
- All possible lines are indicated in § 2 - section IV - Parameter list
. . .
Press the plus or minus button to enter the required value (rep. c). The setting will be stored as soon as you leave the programming mode or change to another line.
- The parameter list containing all possible settings is indicated in § 2 -
section IV - Parameter list
By pressing the Info button, you leave the programming mode "heating engineer"
Permanent display
- 8 -
