Avidsen ASTRELL 300 Manuel utilisateur

To program a remote control, open the control box and locate the RF button on the electronic board, typically near the 'Auto' button. Press the RF button for 2 seconds until LED1 turns off. Within 10 seconds, press a button on the remote control; LED1 will flash 3 times to confirm. The system supports up to 10 remotes. To erase all programmed codes, press the 'Clear' button for 2 seconds.

To program a remote control, open the control box and locate the RF button on the circuit board, typically near the 'Auto' button. Press the RF button for 2 seconds until LED1 turns off, then press a button on the remote control within 10 seconds; LED1 will flash 3 times to confirm. The system can store up to 10 remotes. To erase all programmed codes, press the 'Clear' button for 2 seconds.

To program a remote control, open the control box and press the RF button for 2 seconds until LED1 turns off. Within 10 seconds, press a button on your remote; LED1 will flash 3 times to confirm. The RF button is located on the electronic circuit board inside the control box, near the connectors and the 'Auto' programming button.

To program a remote control, open the control box and locate the RF button on the electronic card, typically near the 'Auto' button. Press the RF button for 2 seconds until LED1 turns off, then press a key on the remote within 10 seconds; LED1 will flash 3 times to confirm. The system can store up to 10 remotes. To erase all programmed codes, press the 'Clear' button for 2 seconds.

To program the remote, open the control box and press the RF button for 2 seconds until the LED turns off. Within the next 10 seconds, press a button on the remote; the LED will flash three times to confirm. The RF button is located on the electronic board inside the control box, typically near the 'Auto' button.

Open the control unit to access the electronic board. Press the RF button (located near the connectors and the 'Auto' button) for 2 seconds until LED1 turns off. Within 10 seconds, press a button on the remote; LED1 will flash 3 times to confirm storage. The system can store up to 10 remotes. To clear all codes, press the 'Clear' button for 2 seconds.

Pour programmer votre télécommande, suivez ces étapes en vous positionnant devant le boîtier de commande ouvert :

1. Appuyez sur le bouton RF pendant 2 secondes. La LED1 s'éteindra.
2. Dans les 10 secondes qui suivent, appuyez sur une touche de votre télécommande. La LED1 clignotera alors 3 fois pour confirmer la mémorisation. Notez que le système peut mémoriser jusqu'à 10 télécommandes. Si vous souhaitez effacer tous les codes programmés, appuyez sur le bouton Clear pendant 2 secondes. Le bouton RF est situé à l'intérieur du boîtier de commande. Vous pouvez le localiser sur la carte électronique, généralement à proximité des connecteurs et du bouton de programmation 'Auto'.